3D print Tokyo

Marunouchi packs Tokyo Station, office towers and the Imperial Palace moat into one frame. Frame it for a solid STL. Heights are estimated from OpenStreetMap tags and labelled as estimated.

Free · no account · STL in millimetres

3D-printable city model of Tokyo, centred on Tokyo Station and Marunouchi
Tokyo, Tokyo Station and Marunouchi — the model as exported, 900 m across
Heights
Estimated from map data
Source
OpenStreetMap
Frame
900 × 900 m
At 180 mm
1 : 5,000 · 51.8 mm tall
Buildings
378

A Tokyo model you can print

Tokyo is enormous, but the area around the station is orderly. Marunouchi is a district of tall office blocks along straight avenues, and it sits right next to the green and water of the Imperial Palace grounds. On a print this makes a sharp contrast: dense towers on one side, a flat park and moat on the other. Japan is outside the laser-survey regions, so heights are estimated from map tags.

The 900 m frame is centred on Tokyo Station and Marunouchi. The red-brick station building lies along the east side of the district, and Gyoko-dori runs west from it toward the palace. The JP Tower stands beside the station plaza. The palace moat is cut as water, and the park layer shows the grounds as a raised plate.

In this frame

  • Tokyo Station
  • Gyoko-dori
  • JP Tower
  • Imperial Palace moat

Printing Tokyo

  • Switch water on to cut the palace moat. It gives the model a clear edge against the dense towers.
  • Switch parks on to show the palace grounds as a raised plate beside the district.
  • Print at 200 mm or larger. Tall office towers are the thin, fragile points of the model.
  • Compare tall towers in the preview with your own knowledge, since estimated heights may be off.
Are Tokyo's building heights measured?
No. Japan is outside the tool's laser-survey regions, so heights are estimated from OpenStreetMap tags for building height and number of floors. The tool labels the model as estimated, and some landmarks use volunteer-made 3D models.
Can I print more than Marunouchi?
Yes. Draw a rectangle up to 4 km on a side. Tokyo is huge and dense, so at 180 mm a very large frame loses small buildings. A frame of 1 to 1.5 km is a good compromise for a readable print.

More cities to print

All cities