3D print Lyon

Lyon sits on a narrow peninsula between two rivers, which makes it a clear and tidy print. Frame the Presqu'île around Place Bellecour and get a solid STL with heights measured by IGN LiDAR HD.

Free · no account · STL in millimetres

3D-printable city model of Lyon, centred on Presqu'île and Place Bellecour
Lyon, Presqu'île and Place Bellecour — the model as exported, 900 m across
Heights
Measured by laser survey
Source
IGN LiDAR HD
Frame
900 × 900 m
At 180 mm
1 : 5,000 · 14.7 mm tall
Buildings
1,294

A Lyon model you can print

The Presqu'île is a long tongue of land squeezed between the Rhône and the Saône. On a printed model that gives you three strong bands: two river channels and a dense urban strip between them. Streets are regular, blocks are mid-rise, and the hills above the peninsula add relief if you leave terrain on. The result looks organised from any angle and prints without fragile parts.

The 900 m frame is centred on Place Bellecour, one of the largest open squares in France, so it appears as a wide empty plate in the middle of the model. Around it you will see the Hôtel-Dieu along the Rhône side, the church of Saint-Nizier just beyond the north edge and the dense Presqu'île blocks running away in both directions. The square is a useful check on print flatness.

In this frame

  • Place Bellecour
  • Hôtel-Dieu de Lyon
  • Pont Bonaparte

Printing Lyon

  • Rotate the frame a few degrees so its sides follow the peninsula. The strip then fills the print instead of leaving dead corners.
  • Keep terrain on. The slopes of the Croix-Rousse and Fourvière hills rise at the frame edges and give the print depth.
  • Use water to cut both rivers. The channels frame the Presqu'île and make the model easy to orient at a glance.
  • A 900 m frame at 180 mm gives roughly 1:5,000. Buildings stay readable, but narrow lanes inside blocks may close up.
Does the Lyon model include the hills?
Yes, if the terrain layer is on. Ground heights come from the same laser survey as the roofs. In this frame the hills sit mostly at the edges, so a larger frame shows them better, at the cost of smaller buildings on the print.
Can I print the Presqu'île bigger than 180 mm?
Yes. The longest side is adjustable from 60 to 300 mm. A larger print gives more room for small buildings and narrow streets, but it needs a bigger bed and more time. Check your bed size before you pick a scale.

More cities to print

All cities